AIRLESSCO HSS9000 Spezifikationen PDF herunterladen (Seite 19)

Fluid Pump Reinstallation - Refer to Figure 12

1. With the Retaining Ring loosly in place around the pump

piston, thread the Fluid Pump in to the Yoke (186-078)

until the top edge of the Outlet Housing (187-086) is

one thread above the inside edge of the Yoke threaded

bore.

2. Tighten the Jamb Nut (187-088) until it stops against

the bottom edge of the Yoke.

3. Line up the Displacement Rod pin hole with the

Hydraulic Piston pin hole; insert the Piston Pin.

4. Slip the Retaining Ring up around the piston pin bore on

the Hydraulic Piston.

5. Run the machine at full pressure for several minutes

and check for leaks. Release the pressure by following

the Pressure Relief Procedure & readjust the packing

nut per step 7 in the Packing Replacement Procedures

on page 20.

6. Reinstall Front Cover

Piston End

Outlet Ball Guide

Outlet Ball

O-Ring

Outlet Seat

Retainer

187-078

187-079

187-091

106-015

187-081

187-082

ITEM # PART # DESCRIPTION

FIGURE 13 PARTS LIST

SERVICING OUTLET VALVE ASSEMBLY

Disassembly of Outlet Valve - Figure 13

1. Remove Fluid Pump from machine - Refer to Fluid Pump

Removal, Page 16.

2. Remove Outlet Valve Assembly - Follow steps 1-9, Disassembly

of the Fluid Pump, Page 16

3. Carefully hold Piston End (187-078) in vise bottom up to access

7/16" Hex in Retainer (187-082). Remove Retainer.

4. Remove Outlet Seat (187-081). Do not pry, it will chip the edges.

5. Remove PTFE O-Ring (106-015), Outlet Ball (187-091) and

Outlet Ball Guide (187-079).

6. Remove all old packings and glands from Outlet Housing; retain

Male Gland (187-073) and Female Gland (187-072), they will be

re-used unless damaged.

7. Clean and inspect parts for wear or damage, replace parts as

necessary. PTFE O-Ring (106-015) will always be replaced in this

procedure.

Re-assembly of Outlet Valve - Figure 13

1. Install Ball Guide (187-079), Ball (187-091), Seat (187-081) and

O-Ring (106-015) into Piston End.

2. Install Retainer (187-082) into Piston End. Torque Retainer to

30 Ft-Lb.

3. Install new packings, glands and scraper - Refer to Packing

Replacement Procedures, Page 20.

SERVICING THE FLUID PUMP

FIGURE 13

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

AIRLESSCO HSS9000 Spezifikationen Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spritzpistole AIRLESSCO HSS9000