AIRLESSCO HSS9000 Spezifikationen PDF herunterladen (Seite 12)

4. Adjusting the pressure

a. Turn the Pressure Control Knob Clockwise to

increase pressure and counterclockwise to decrease

pressure.

b. Always use the lowest pressure necessary to

completely atomize the material.

Note: Operating the sprayer at higher pressure

than needed, wastes material, causes early tip

wear, and shortens sprayer life.

c. If more coverage is needed, use a larger tip rather

than increasing the pressure.

d. Check the spray pattern. The tip size and angle

determines the pattern width and ow rate.

WARNING

When you spray into the paint bucket,

always use the lowest spray pressure

and maintain rm metal to metal contact

between gun and container.

To stop the unit in an emergency, turn the

motor off. Then relieve the uid pressure

in the pump and hose as instructed in the

Pressure Relief Procedure.

WARNING

Follow the "Pressure Relief Procedure".

To reduce the risk of injection, never

hold your hand, body, ngers or hand

in a rag in front of the spray tip when

cleaning or checking for a cleared tip.

Always point the gun toward the ground

or into a waste container when checking

to see if the tip is cleared or when using

a self-cleaning tip.

5. When Shutting off the Sprayer

a. Whenever you stop spraying, even for a short break,

follow the "Pressure Relief Procedure".

b. Clean the tip & gun as recommended it the spray gun

instruction manual.

c. Flush the sprayer at the end of each work day, if the

material you are spraying is water-based, or if it could

harden in the sprayer overnight. See "Flushing". Use a

compatible solvent to ush, then ll the pump and hoses

with an oil based solvent such as mineral spirits.

d. For long term shutdown or storage, refer to the

"Flushing" section of this manual.

WARNING

Be sure to relieve pressure in the pump after

lling with Airlessco Pump Conditioner.

Avoiding Tip Clogs

There is an easy way to keep the outside of the

tip clean from material build up:

Every time you stop spraying, for even a minute,

lock the gun and submerge it into a small bucket

of thinner suitable for the material sprayed.

Thinner will dissolve the buildup of paint on the

outside of tip, tip guard and gun much more

effectively if the paint doesn't have time to dry

out completely.

SETTING UP (continued)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

AIRLESSCO HSS9000 Spezifikationen Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spritzpistole AIRLESSCO HSS9000