AIRLESSCO HSS9000 Bedienerhandbuch PDF herunterladen (Seite 7)

SETTING UP

1. CONNECT THE HOSE AND GUN

a. Remove the plastic cap plug from the outlet and screw a

conductive or grounded 3000 psi spray hose onto

uid outlet.

b. Connect an airless spray gun to the other end of the

hose, but do not install the spray tip yet!

NOTE: Do not use thread sealer on swivel unions as they

are made to self seal.

3. CHECK THE ENGINE OIL LEVEL

4. FILL THE FUEL TANK

FIG. 1

2. FILL THE PACKING NUT/WET CUP

Fill the Packing Nut/Wet

Cup with 5 drops of

Airlessco Throat Seal

Oil (TSO).

WARNING: Fuel spilled on a hot surface can cause a re or

explosion and cause serious bodily injury and property dam-

age. Always shut off the engine and let it cool before lling

the tank, and carefully follow steps a - c below being sure not

to spill any fuel.

WARNING

a. Unscrew the oil ll plug. The dipstick is attached to

the plug.

b. Without threading the plug into place, check to be sure

the oil is up to the top mark on the dipstick.

c. If oil is needed, refer to engine manual.

a. Close the fuel shutoff valve.

b. Use only clean, fresh, well-known brands of unleaded

regular grade gasoline.

c. Remove the fuel cap and ll tank. Be sure the air vent

in the ll cap is not plugged so fuel can ow to the

carburetor, then replace the cap.

Your unit was factory tested in an oil solution which was left

in the pump. Before using oil-base paint, ush with mineral

spirits only.

Before using water-base paint ush with mineral spirits,

followed by soapy water, then a clean water ush.

Flush with a compatible solvent such as mineral spirits or

water.

Flush with soapy water, then mineral spirits.

Flush with mineral spirits, followed by soapy water, then a

clean water ush.

3. CHANGING FROM WATER-BASE TO

OIL-BASE PAINT

4. CHANGING FROM OIL-BASE TO

WATER-BASE PAINT

Oil-base paint: Flush with mineral spirits.

Water-base paint: Flush with water, then mineral spirits and

leave the pump, hose and gun lled with mineral spirits.

For longer storage, use mixture of mineral spirits and motor

oil (half & half). Shut off the sprayer, follow PRESSURE

RELIEF PROCEDURE on page 9 to relieve pressure and

make sure prime valve is left open.

Before using water-base paint, ush with soapy water and

then a clean water ush.

When using oil-base paint, ush out the mineral spirits with

the material to be sprayed.

1. NEW SPRAYER 5. STORAGE

6. START UP AFTER STORAGE

FLUSHING

2. CHANGING COLORS

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

AIRLESSCO HSS9000 Bedienerhandbuch Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spritzpistole AIRLESSCO HSS9000